Shanghai Yexu Bearing Co.,Ltd
High quality product, professional service, being the core supplier in Bearing industry!

E-mail: info@shyexu.cn
Home > News > Content
Installation Of Fan Bearings
- Oct 31, 2017 -

The base of the bearing and blower is based on the installation of the raetts Rez blower often seen in two parts, the use of these two components, mainly in the installation process, the installation of some problems If you can not get the user's attention, the fan will There are many problems, the use of results can not be guaranteed.

The installation of the bearing base and the basis of some data must be accurate, thus protecting the Reiter fan installation properly.

The horizontal level should not exceed 0.2 / 1000 at the level of the spindle measurement, the horizontal bottom should not exceed 0.3 / 1000, by measuring the level of the bearing surface. This value directly affects the use of the Reiter blower, and therefore must arouse the user's attention.

Timing Reiter centrifugal fan, fan shaft and motor shaft different shaft radial position deviation should not exceed 0.05 mm, tilt should not exceed 0.2 / 1000. Centrifugal fan bearing assembly, different shaft bearing hole frame, can be installed in the rotor, rotating flexible prevail.